ISONEM EP PRIMERis a two-component epoxy resin primer, easy to apply, with perfect adhesion. It has low viscosity, good moisture tolerance, and very good penetration.

ISONEM EP PRIMERincreases the strength of concrete by filling capillary cavities in floors and acts as an adhesion bridge between concrete, paints and epoxy or polyurethane topcoats.

EP PRIMER

Quantity

ISONEM EP PRIMERsuitable for interior and exterior floors and walls made of concrete, aerated concrete, plaster, roughcast and similar rough walls, old lime paint, raw wood, marble, granite, tiles and ceramics, and metal.
SURFACE PREPARATION:

Remove all loose, unattached material from the surface. Clean all oils and dirt from the surface by sandblasting. The surface temperature must be +3°C above the dew point during application. Prepare the mixture in sufficient quantity for the application taking into account the pot life of the mixture. Before you start, make sure the temperature of the material is between 15 and 25°C.

APPLICATION METHOD:

Thoroughly mix component A of ISONEM EP PRIMER with a mixer at 300 - 400 rpm for 2 - 3 minutes without creating air bubbles. Then, pour all of component B into component A. Mix for at least 4 minutes until a homogeneous mixture is obtained. Use the mixture within 30 to 40 minutes at most. If necessary, remove air in the application with a spiked roller.

TOOL CLEANING:

Clean all tools and application equipment with aromatic solvent-based thinner.

EP PRIMER

Job

Implementation